Grout 300 Series || Tipro Industries

Tipro 300 series sanded grout is made of blended portland cement, graded aggregates, fortifiers and pigments, it provides a tile joint that is strong, hard, durable and colourfast. Designed for joint width of 3mm to 12mm for non-absorbent and vitreous tiles, it is suitable for interior and exterior use.

When the tiles/ stones have set firm, spacers and bottom support can be removed.
Cement based colour Grout
Use Tipro 200 series when grout joints are less than 3 mm wide and Stone Filler Grout 300 Series Sanded Grout Filler (available in a range of colours) for joints 3mm – 12mm.
The Cement based colour joints are strong and are resistant to weather, cracking and discolouration.
Mixing Ratio:
10kg bag : 3.75 ltr
Stone Filler Grout 300 Series Sanded Grout : 176 Power Grout Admixture
10 kg bag : 1.75 ltr
Mix the grout filler with 176 Power Grout Admixture, mix only enough that can be used in 30 min or less. Clean up immediately before beginning next mix.
When applying, the grout joints should be free of dirt, debris or tile spacers. Sponge or wipe dust/dirt of tile faces and remove water standing in joints. Pack joints full and free of voids with rubber grouting float. Remove excess grout from tile faces using edge of rubber float and diagonal strokes (at 45° angle to direction of joints). When the joints have set, use a moist sponge to remove excess grout from the tile and joint. Use minimal water for clean up. Final clean up to remove any grout haze should be carried out within the next 12 – 24 hours.

For Best Performance Use Tipro 176 Admixture Power With Tipro Tile Grout 300 Series.

Grout 300 Series